• The forum upgrades have been completed. These were moderate security fixes from our software vendor and it looks like everything is working well. If you see any problems please post in the Forum Technical Support forum or email us at forum_moderator (at) aawforum.org. Thank you
  • Congratulations to Bernie Hyrtzak, People's Choice in the January 2026 Turning Challenge (click here for details)
  • Congratulations to David Croxton for "Geri's Basket Illusion" being selected as Turning of the Week for February 2, 2026 (click here for details)
  • AAW Symposium demonstrators announced - If the 2026 AAW International Woodturning Symposium is not on your calendar, now is the time to register. And there are discounts available if you sign up early, by Feb. 28. Early Bird pricing gives you the best rate for our 40th Anniversary Symposium in Raleigh, North Carolina, June 4–7, 2026. (There are discounts for AAW chapter members too) For more information vist the discussion thread here or the AAW registration page
  • Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.

Removing CA glue

Acetone works well until CA dries, but after that AFAIK your only options are careful application of an abrasive.
 
since it soaks in well below the surface, you will have a hard time even cutting out without seriously altering the shape. You can sand it back to the surface, but you will still have the "wet" spot of glue. May be better off "dying" the whole piece with more glue.
 
I agree with Steve. It's very hard to sand the glue stain away. By soaking the whole thing with thin CA you take away much of that stained look.
 
Any film finish will match at the second or third coat. I use shellac on my ornaments because it's fast and shiny.
 
There is a solvent sold at Woodcraft that works even on dried CA. Like the others, I have found that acetone does not work on dried CA. I have tried the solvent inside joints and on my fingers, but not on spillage on prepared surfaces. You could try it, but frankly it might be better to use MM's suggestion and build up coats to match.
 
The solvent (at least some portion of it) is Nitromethane in Stickfast's De-Bonder. You may try a hobby store that caters to gas powered RC hobbyists. They use Nitromethane in their fuel mix.
 
You must log in or register to reply here.
Back
Top