Not long before I shut down my shop, I bought the sanding-/honing-wheel set-up seen in the picture below. It was made by a professional turner who was retiring (I think you'd recognize his name if I could only remember it!). Since it was an impulse buy (went there to get a powered respirator), I tucked it in a corner of the shop and never got to using it. I tried it out today when reshaping the evil oval skew, kinda like it, but am curious what folks would recommend regarding grits to put on it (2 sanding wheels), and how to use the rubber wheel. And any other tips. It's been so long, I can't remember what the previous owner suggested. It is variable speed and perhaps reversible.