-
Beware of Counterfeit Woodturning Tools (click here for details) -
Johnathan Silwones is starting a new AAW chapter, Southern Alleghenies Woodturners, in Johnstown, PA. (click here for details) -
Congratulations to Peter Jacobson for "Red Winged Burl Bowl" being selected as Turning of the Week for April 29, 2024 (click here for details) -
Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.
segmented bowl
- Thread starter ryan34
- Start date
- Joined
- Jan 23, 2007
- Messages
- 105
- Likes
- 0
if you use say Titebond lll which is water proof that may do it, if you use a hide glue or urethane glue that should be ok, if you use CA type glues they are impervious to citric type acids. check the mfgr's for sure. but it is the finish you need to use a food safe that will protect the wood and the joint at the same time. epoxy is is good also, but once again I have found the finish will protect everything.Surface finishes need reaplying on occasion so, were it me I would set up some tests and see what happens using as many as you are willing to test just to have a good spread.
Richard Baker
RIP
Use T. III and see related threads for finish of choice. Hand wash and dry immediately after use (vs. letting it sit in the sink overnight).