-
December 2025 Turning Challenge: Single Tree! (click here for details) -
Congratulations to Bob Henrickson, People's Choice in the November 2025 Turning Challenge (click here for details) -
Congratulations to Steven Gordon for "Dropped Ice Cream Cone" being selected as Turning of the Week for December 8, 2025 (click here for details) -
Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.
Spindle lock on PM 3520C -- Reminder Tip
- Thread starter Greg Carles
- Start date
I don't have that lathe, but it looks like an outstanding idea.
I think I'll do that, I left it locked a couple of times when I started it yp.
Good tip Greg, You should turn it in to Joshua Friend to get published in American Woodturner. I put the red tape on mine and it already helped me out once. I'm going to get some green tape too. I have a bad habit of locking it and removing the chuck and get sidetracked doing something else and forget to check it.
I've often wished lathe makers would add a simple switch to inform the low voltage VFD control circuit when the spindle lock was engaged.
But decades ago when consulting for a scientific instrument maker I learned the actual cost to make even a simple addition when considering things like design/engineering, parts sourcing, testing, production line changes, and even documentation. A clever DYIer could probably do a one-off for little or nothing.
But decades ago when consulting for a scientific instrument maker I learned the actual cost to make even a simple addition when considering things like design/engineering, parts sourcing, testing, production line changes, and even documentation. A clever DYIer could probably do a one-off for little or nothing.
I believe Robust has this standard.
Thank you Greg I'm on my way out the door for the colored tape.