• July 2025 Turning Challenge: Turn a Multi-axis Weed Pot! (click here for details)
  • Congratulations to James Seyfried for "NE Red Oak II" being selected as Turning of the Week for July 21, 2025 (click here for details)
  • Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.

tailstock center extension

Charlie Knighton

Charlie Knighton

Joined
Jan 20, 2006
Messages
2,057
Likes
404
Location
Martinsville, VA
anybody know if somebody makes a tailstock center extension?
 
tailstock extension

I have the one from Craft Supply. From the face of the tailstock spindle to the face of the extension is 4 1/4 inches. When using be sure to clean both the inside of the spindle and the taper of the extension EVERY time you use it. Also, depending on the lathe you may get some runout if the tailstock spindle is cranked out to near max.
 
thanks, i looked in cs, did not see it, relooked and there it is

thanks again and i did note to clean with reaming before and after, good idea
 
You must log in or register to reply here.
Back
Top