Was here some time ago, business took a dive so back burnered lathe purchase.
Trying again, scaling back a little from jumping right to a PM3250.
What would be a decent 110v electronic variable speed unit (rather than belt or reeves) for starting a little more economically ? Jet, Delta, Nova or ?
Midi, 1236, 1442 size ? I know a lot has to due with what will be turning but have to start somewhere with something that is not too limiting.
And just as important a sharpening system that will function on my 6" grinder.
Had taken a 1 on 1 class sometime ago and will try start going to AAW chapter meeting in 1/12.
Off topic, what happened to older posts ?
Thanks !
Trying again, scaling back a little from jumping right to a PM3250.
What would be a decent 110v electronic variable speed unit (rather than belt or reeves) for starting a little more economically ? Jet, Delta, Nova or ?
Midi, 1236, 1442 size ? I know a lot has to due with what will be turning but have to start somewhere with something that is not too limiting.
And just as important a sharpening system that will function on my 6" grinder.
Had taken a 1 on 1 class sometime ago and will try start going to AAW chapter meeting in 1/12.
Off topic, what happened to older posts ?
Thanks !
Last edited: