I'm trying to figure out how to set the leg on the varigrind. Is there a tutorial that shows the effects of setting it one way or the other? I read that the leg controls the angle of the nose while others say the opposite (wing). I dont understand in this case if the angle of the wing vs the nose would be different or the same? If same, then does the leg affect how far back the sweep could go?
I have some micro tools that are too short and dont have enough steel to protrude the required 1 -3/4 inches from the jig and other tools that will not clamp down fully due to the tool being thicker where the end of the flute reaches the steel.
I've watched pretty much every video and none explain what the leg does. Well, at least they don't demonstrate it in practice. Anyone got a good resource or reading material for me to better understand how to use the tool for my purposes?
I have some micro tools that are too short and dont have enough steel to protrude the required 1 -3/4 inches from the jig and other tools that will not clamp down fully due to the tool being thicker where the end of the flute reaches the steel.
I've watched pretty much every video and none explain what the leg does. Well, at least they don't demonstrate it in practice. Anyone got a good resource or reading material for me to better understand how to use the tool for my purposes?