• July 2025 Turning Challenge: Turn a Multi-axis Weed Pot! (click here for details)
  • Congratulations to James Seyfried for "NE Red Oak II" being selected as Turning of the Week for July 21, 2025 (click here for details)
  • Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.

Using unlace or what ever to fill cracks

Joined
Jan 3, 2015
Messages
175
Likes
99
Location
Western Ma.
Anyone know of a good video or two on the process of preparing cracks and voids to receive inlave or brass fillings? Looked on YouTube, but not seeing much showing the process start to finish. Thanks any help is appreciated.
 
You do not need to prep a crack to fill with Inlace. It is an epoxy so just clean out the loose fibers and apply tape to back side so it does not go thru. Overfill or do more than one application to insure no voids. If the crack is long or in the round they make a filler or thickener to help stopping a run out.

If you want to decorate your bowls cut a dovetail slot in bowl and go for it.
IMG_6783.JPG
 
I don't get the crack repair situation in the first place. A bowl cracks, it gets cut up and goes in the smoker. But to draw even more attention to a crack really doesn't make sense. Is there a turning wood shortage in Western, Ma?
 
Much depends on the size of the crack and the colour of the wood, and of course the cost or rarity of the wood. I have some fairly hard to get and rare blanks, with these I fill as required.
Fine cracks in dark wood I just fill them with CA, larger cracks I fill with resin thats coloured to suit or ebony powder. Preparation very little if any other than what has already been commented on.
 
Back
Top