Thanks for the reply, trying it now.I would try this... Open jaws a bit, loosen all jaw screws, then tighten them down, snug, but not so snug the jaws can't move.
now tighten jaws, like you are gripping a tenon and see if the jaws don't rotate into place, if they do, tighten the jaw screws...
And rejoice... If not, someone else will have a better answer.
Yes, I went ahead and tightened everything up. I tried the advice from earlier and it helped. Still a small gap I’ll take a picture when I get back home.Are the jaws mounted in the base piece?
Stronghold
This is a good practice for any brand of chuck.I would try this... Open jaws a bit, loosen all jaw screws, then tighten them down, snug, but not so snug the jaws can't move.
now tighten jaws, like you are gripping a tenon and see if the jaws don't rotate into place, if they do, tighten the jaw screws...
And rejoice... If not, someone else will have a better answer.