Vicmarc Dovetail Jaw 2 step 70mm

[Andre Omland]

Has anybody used thoose?
Wood like them for mye VM100 chuck but dont like the fact that its a 2 step as im only interested in the widest part and im curious as to how deep it is.

I really like the specs on the 85mm DT jaws for the VM120, hust to bad they dont make it for the VM100.

 

[Wyatt Holm]

I'm not exactly sure which set your asking about. This may answer your question:

View: https://youtu.be/qKLjtu6n2o8

 

[Andre Omland]

This is the set i am asking about:

https://www.vicmarc.com/product-page/dovetail-jaws-vm90-100?currency=

I am wondering if anyone has used the 70 mm and can share there experience?

Ive watched the video but that is the regular step jaws, not the jaws in asking about.

The vicmarc site does not show how deep each dtep is, only the total debt.

Id like to now how deep the part thats 55mm wide is.

 

[Brian Gustin]

This is the set i am asking about:

https://www.vicmarc.com/product-page/dovetail-jaws-vm90-100?currency=

I am wondering if anyone has used the 70 mm and can share there experience?

Ive watched the video but that is the regular step jaws, not the jaws in asking about.

The vicmarc site does not show how deep each dtep is, only the total debt.

Id like to now how deep the part thats 55mm wide is.

Based on the dimensions, if the drawing is to scale, I'd suspect the depth of each of the dovetails would be about 6mm which is generally fairly meaty dovetail for most turnings .. I've worked with dovetails as shallow as 1/16" (a bit over 1mm I think) but usually only for fine tuning and finish cuts - more important is getting the "perfect circle" diameter where the jaws have full contact the entire circumference on cases like that..