In my search for handle knobs I found indexing plungers. Where have they been all my turning days? One of my peeves is having to hold the pin in to lock the spindle and if you don't it usually falls into the pile of shavings unless you screw it into the threaded indexing holes.
Anyone wouldn't happen to know the thread and pin size of the spindle pin for a grizzly g0766 would they? Otherwise it's a 40 mile round trip to either get batteries for my caliper or go to a big box store and try to match up nuts to figure out the size of the plunger needed.
This isn't really a necessary item just a handy one. Most of the other lathes have a spindle lock that doesn't fall in the shavings don't they?
Anyone wouldn't happen to know the thread and pin size of the spindle pin for a grizzly g0766 would they? Otherwise it's a 40 mile round trip to either get batteries for my caliper or go to a big box store and try to match up nuts to figure out the size of the plunger needed.
This isn't really a necessary item just a handy one. Most of the other lathes have a spindle lock that doesn't fall in the shavings don't they?