I make my own NR scrapers from stock HSS I buy on amazon. It's not expensive and I like it as well as anything I've bought from a tool mfg. Approx. 12"x1"x1/4" is a good size for most of what I do. I have a pocket handle that lets me put a different shape on each end and swap end to end as needed. Easy to make, just a snug fit but one you can slide out and back in without a struggle. A little paraffin helps. Most of my NR scraper work is done up close so don't need a long handle but something flat and easy to hold is better than just holding the bare steel. the magnet is just a reminder of which side has the burr. One of those things that I'm sure others have done, done better and not a new idea but something that's new for me.
I searched and could not find a similar post. Apologies if a duplicate.
I searched and could not find a similar post. Apologies if a duplicate.