I can get a pretty decent finish cut on the inside of my hollow forms but I’m pretty new to this and my idea of decent might be skewed.
I’ve never seen any other hollow forms in person and am curious about how far people go to get a perfect interior surface. Also any tips would be welcome.
My second hollow form, it’s Alaskan birch. I was able to get this one pretty thin because the light shines through. Any advice or feedback is greatly appreciated. I haven’t found any other wood turners in my area. I’m sure they exist. Anyone in Fairbanks area??
(Sorry, I just read the sticky that says “read this before posting” hopefully one of the nice moderators will move it to where it belongs)
I’ve never seen any other hollow forms in person and am curious about how far people go to get a perfect interior surface. Also any tips would be welcome.
My second hollow form, it’s Alaskan birch. I was able to get this one pretty thin because the light shines through. Any advice or feedback is greatly appreciated. I haven’t found any other wood turners in my area. I’m sure they exist. Anyone in Fairbanks area??
(Sorry, I just read the sticky that says “read this before posting” hopefully one of the nice moderators will move it to where it belongs)