I found I needed a different type of vice to hold some of my bowls for embellishments, especially the larger ones. So I came up with this plywood and Ironbark with a capacity of 200x200 or 8x8"
-
It's time to cast your vote in the April 2025 Turning Challenge. (click here for details) -
Congratulations to Steve Bonny for "A Book Holds What Time Lets Go" being selected as Turning of the Week for 28 April, 2025 (click here for details) -
Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.
A simple wooden vice
- Thread starter hughie
- Start date
- Joined
- Feb 28, 2021
- Messages
- 1,587
- Likes
- 1,386
- Location
- Roulette, PA
- Website
- www.reallyruralwoodworks.com
Cool. a nice take off an old style wooden Knee Vise / Leg Vise , scaled down to bench size... I like it.
How did you attach the vise to the bench?
How are the sliding mounts at the bottom of the vise jaws fixed in place?
How are the sliding mounts at the bottom of the vise jaws fixed in place?
The backing plate in 1" plywood is fixed to the metal frames of the bench by Buildex screws, might have gotten carried away there as I used a lot them 
The locking set up is as you can see just a 1/2" UNC screwed rod. There are a couple plates that slide in order to give some support to the Ironbark jaw 
The locking set up is as you can see just a 1/2" UNC screwed rod. There are a couple plates that slide in order to give some support to the Ironbark jaw