• The forum upgrades have been completed. These were moderate security fixes from our software vendor and it looks like everything is working well. If you see any problems please post in the Forum Technical Support forum or email us at forum_moderator (at) aawforum.org. Thank you
  • February 2026 Turning Challenge: Cookie Jar! (click here for details)
  • Congratulations to Chad Eames for "Red Tines" being selected as Turning of the Week for February 23, 2026 (click here for details)
  • AAW Symposium demonstrators announced - If the 2026 AAW International Woodturning Symposium is not on your calendar, now is the time to register. And there are discounts available if you sign up early, by Feb. 28. Early Bird pricing gives you the best rate for our 40th Anniversary Symposium in Raleigh, North Carolina, June 4–7, 2026. (There are discounts for AAW chapter members too) For more information vist the discussion thread here or the AAW registration page
  • Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.

Baxter's Threadmaster for Vicmarc VL 100 (10 inch swing) Colorado Springs, Co

Status
Not open for further replies.
D

Dr. Bob

Joined
Apr 6, 2007
Messages
12
Likes
0
I'm selling this for the widow of a club member. It's never been used. The Best Tools site lists it at $ 500 and it also has two 2 inch face plates listed at $ 60 so a value of $ 560 if my math is correct. The Best Tools site also says it is for lathes with a 9" to 12 1/2" swings with the right height riser. This one has the 10" one for the VL 100 or the Jet 1014. The cutter is TC 75, 3/4 inch.

Asking $ 400 plus shipping (it should fit into a large flat rate USPS box $ 21 or so).
(Or available for pick up in Monument, Colorado)

Robert Gibbs
E mail bobandcamilla@comcast.net
Home phone 719 488 9487Baxter's Threadmaster.jpeg
 
Status
Not open for further replies.
Back
Top