• January 2026 Turning Challenge: Turned and Bent! (click here for details)
  • Congratulations to Phil Hamel, People's Choice in the December 2025 Turning Challenge (click here for details)
  • Congratulations to Clayton Thigpen for "Armillary Sphere" being selected as Turning of the Week for January 19, 2026 (click here for details)
  • Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.

Bowl depth

H

Heath Warren

Joined
Oct 31, 2025
Messages
3
Likes
3
Location
Gurnee, IL
I think I knew I was getting too thin on the bottom. It was going so well until I cut the tenon off. What are some good bowl depth gauges you use? Shop made is just fine.
 

Attachments

  • IMG_6994.jpeg
    IMG_6994.jpeg
    372.2 KB · Views: 12
You could consider some of the alternative gauges that Doc Green has documented on his website in the Gauges section of his Articles webpage.

I would love to say that I have never had the inside diameter exceed the outside diameter, but that wouldn't be accurate.

Good luck!
 
Jim Reynolds said:
You could consider some of the alternative gauges that Doc Green has documented on his website in the Gauges section of his Articles webpage.

I would love to say that I have never had the inside diameter exceed the outside diameter, but that wouldn't be accurate.

Good luck!
Click to expand...
Thanks. I’ll check it out. This was the first time it happened. I’m sure it won’t be the last
 
You must log in or register to reply here.
Back
Top