Hello everybody! I suppose it’s finally time I write an introduction after having hung out in here for a while now.
My name is Clark. I am a member of the Ohio Valley Woodturner’s Guild and have been turning for about a year and a half. Most of that has been at the guild’s workshop; however, my wife recently gifted me a Powermtic 3520c as an early gift for (finally) finishing graduate school!
I have had some awesome mentors at the guild and in my father-in-law, Rex Burningham (some of you may recognize the name).
Time in the shop recently has been harder to come by recently due to a number of things but most excitingly the addition of our first child which is a mix welcomed trade off (I am writing this post as I’m up with him doing a night time feed).
My main interests currently are far grain projects like bowls, platters, and plates, but I am wanting to expand into hollow forms as well.
My name is Clark. I am a member of the Ohio Valley Woodturner’s Guild and have been turning for about a year and a half. Most of that has been at the guild’s workshop; however, my wife recently gifted me a Powermtic 3520c as an early gift for (finally) finishing graduate school!
I have had some awesome mentors at the guild and in my father-in-law, Rex Burningham (some of you may recognize the name).
Time in the shop recently has been harder to come by recently due to a number of things but most excitingly the addition of our first child which is a mix welcomed trade off (I am writing this post as I’m up with him doing a night time feed).
My main interests currently are far grain projects like bowls, platters, and plates, but I am wanting to expand into hollow forms as well.
