Fors Sale: Vicmarc VM120 Chuck

[Larry Steinmetz]

Hello,

i unfortunately purchased the wrong Vicmarc chuck several months ago. It would cost ~$60 to send back to Australia so I am going to sell it here. It is still in the box it came in as I am still setting up my shop and still have not even fired up my new lathe. I am asking $195 plus shipping from Houston, TX.

Specs:

1 x VM120 Chuck
1 × 1 1/4” x 8 Insert
1 x Standard Jaws (V00285-5)
1 x 4mm Allen T-Bar Allen Key
1 × 10mm T-Bar Allen Key
1 x Woodscrew

Thanks for your interest!

 

[Raif Harik]

Hi, is it just the chuck or does it come with a thread insert? If so what is the TPI/size?
Thanks

 

[David McWilliams]

I would like to buy your chuck. How would you like to work out the payment?

Thanks
David

 

[Raif Harik]

Hi I didn't see you had the specs there. If you have not sold it to Mr. McWilliams, then I would like it.
Raif

 

[Roger Wiegand]

Thanks guys for saving me from buying a fourth one. Not changing jaws is addicting.

 

[Timothy Allen]

Haha, would have been only my second VM120, but fourth chuck overall....

 

[Scott Kershaw]

Should the above requests fall through, please consider selling it to me.

 

[David McWilliams]

Hi Larry,
Should we make financial and mailing address off line? my email is "kurmacdavid@gmail.com". Thanks so much.
David

 

[Paul Grenier]

I would have happily made that my #5 chuck if I had seen it first.

 

[Mike Johnson]

Ditto.

 

[Raif Harik]

It sounds like Mr McWilliams is the winner here, but regardless I would like to withdraw my bid. It seems like there are plenty of eager candidates so that should not be a problem
Raif

 

[Larry Steinmetz]

Hello all,

Sorry for my late response. I will contact individuals privately in the order they responded until I have a winner. Thanks all for your interest!

 

[Larry Steinmetz]

I've sent a message and an email to a forum member who said they wanted the chuck. If I don't hear from them by tomorrow morning I'll move down the list. Thanks.

 

[Emiliano Achaval]

Hello,

i unfortunately purchased the wrong Vicmarc chuck several months ago. It would cost ~$60 to send back to Australia so I am going to sell it here. It is still in the box it came in as I am still setting up my shop and still have not even fired up my new lathe. I am asking $195 plus shipping from Houston, TX.

Specs:

1 x VM120 Chuck
1 × 1 1/4” x 8 Insert
1 x Standard Jaws (V00285-5)
1 x 4mm Allen T-Bar Allen Key
1 × 10mm T-Bar Allen Key
1 x Woodscrew

Thanks for your interest!

Did you sell it?

 

[Dean]

Although late to the conversation, If all above fall through I would buy it

 

[Mike Johnson]

It might be easier to just auction this tool.

 

[Larry Steinmetz]

Good evening. The chuck has been sold; thanks for all the interest!