• The forum upgrades have been completed. These were moderate security fixes from our software vendor and it looks like everything is working well. If you see any problems please post in the Forum Technical Support forum or email us at forum_moderator (at) aawforum.org. Thank you
  • February 2026 Turning Challenge: Cookie Jar! (click here for details)
  • Congratulations to Chad Eames for "Red Tines" being selected as Turning of the Week for February 23, 2026 (click here for details)
  • AAW Symposium demonstrators announced - If the 2026 AAW International Woodturning Symposium is not on your calendar, now is the time to register. And there are discounts available if you sign up early, by Feb. 28. Early Bird pricing gives you the best rate for our 40th Anniversary Symposium in Raleigh, North Carolina, June 4–7, 2026. (There are discounts for AAW chapter members too) For more information vist the discussion thread here or the AAW registration page
  • Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.

FS: Thin stock ripping jig for table saw

Status
Not open for further replies.
Mark Hepburn

Mark Hepburn

Artist & Chef
Joined
Mar 26, 2014
Messages
2,091
Likes
1,141
Location
Houma, Louisiana
Update: I'll pay the shipping, asking twenty dollars

I continue to purge my shop of things that I know I won't be using to buy toys that I will :)

This is a Fulton thin rip tablesaw jig

I got this it some time ago as a gift from my dearly beloved and never used it. It won't fit my slider, which has a non-standard T-slot, and I'M not going to tell her. Perhaps someone can use this. Still in the box and never used. Im asking $20 and will pay postage in the US.

It sells over at Peachtree for $29.95.

Thanks,

Mark


IMG_5446.JPG IMG_5448.JPG IMG_5449.JPG
 
Last edited:
Mike, it's a 3/4" T-slot. Here are some photos of the dimensions

IMG_5460.JPG IMG_5459.JPG


IMG_5458.JPG
 
Jamie, I just sent a reply. Sorry about the delay.
 
Thanks Jon.

If you'll PM your address I'll get it out to you today if I can. Tomorrow for sure if not today
 
Last edited:
Jon,

If you click on Mark Hepburn there is an option to "Start A Conversation".
The message will show up in his message box.
 
Jon Minerich said:
Mark, my apologies. I was busy with family during Christmas. Now for my embarrassment, how do I PM you?
Click to expand...

What Mike Johnson said.

Our forum software uses the word Conversation to mean the same thing as the term Personal Message. That is confusing. We switched over earlier this year from a different forum software that used Personal Message and we're shifting our paradigms to the new terminology which still seems a bit odd after so many years of being accustomed to the previous terminology.
 
Jon, Bill:

Sorry to take so long to reply here. Thanks for picking up my slack Bill.

Sold and shipped to Jon. Thanks!
 
Status
Not open for further replies.
Back
Top