• Congratulations to Phil Hamel winner of the April 2025 Turning Challenge (click here for details)
  • Congratulations to Steve Bonny for "A Book Holds What Time Lets Go" being selected as Turning of the Week for 28 April, 2025 (click here for details)
  • Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.

"General 260 Electronic Variable Speed Wood Lathe" - $2500 (Littleton), CO

Status
Not open for further replies.
D

Dave Reider

Joined
Jan 13, 2018
Messages
6
Likes
0
Location
Littleton, CO
Purchased New 15 years ago and rarely used.......
Like New. Riser Block Assembly.
Comes with the two faceplates that it came with new.
Accessories cost more than the Lathe, and are NOT included!
Excellent condition.
$5,500 to $6,000 New, if you can find one.
$2,500.00 (FIRM).
Serious offers only.
DaveIMG_1843.jpg IMG_1847.jpg IMG_1848.jpg
 
Welcome to the AAW forum, Dave. The lathe appears to be in pristine condition. For those who aren't familiar with the specs on the General 260, could you give the motor horsepower, swing, speed range, etc?

There are many woodturners that read these want ads, but not all of them are members of this forum. In order for any non-members to be able to contact you, they would need either an email or phone number. Sharing that information, of course, is up to you.

Want Ads remain active for 30 days, but you can keep the ad active by posting that it is still for sale before the end of that time. Also, if the lathe is sold please post a reply indicating that it has been sold.
 
Purchased New 15 years ago and rarely used.......
Like New. Riser Block Assembly.
Electronic Variable Speed - Inboard >150< rpm to <3000> rpm (prox.); Unlimited Outboard X 38" bed length. Forward and Reversible.
1 hp. 220/240 volt. (not underpowered, as there is a step-pully assembly for torque.
25" swing over gap (with gap filler block removed) and 20" over bed.
Comes with the two faceplates that it came with new.
Accessories cost more than the Lathe, and are NOT included!
Excellent condition.
$5,500 to $6,000 New, if you can find one.
$2,500.00 (FIRM).
Serious offers only.
AmeriSpecDenver@msn.com

Dave
 
Last edited by a moderator:
Just saying, I had a general 26020 VS with the 2hp motor electronic VS
I had added an extra movable pendant with full controls.
Included the outboard bed extension for a 28” swing plus extra banjo lathe was purchased new in 2008, after near 1 yr on the market it sold for $2700 Canadian, buyer was from the U.S. so they saved an additional 25+% due to the exchange rate.
 
First off, as the pic illustrates, the Lathe is capable of turning 20” diameter and approx. 24+ inch platter with the tailstock filler block removed.
IMG_35801.jpg
 
Status
Not open for further replies.
Back
Top