Does anyone know if the Big Bite can only be used in OneWay chucks, or can it fit into any 4 jaw chuck? Thanks.
-
Congratulations to John K. Jordan winner of the June 2025 Turning Challenge (click here for details) -
Congratulations to John Shannon"Cherry Bowl" being selected as Turning of the Week for June 30 2025 (click here for details) -
Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.
OneWay Big Bite Spur
- Thread starter Ed Weingarden
- Start date
- Joined
- Aug 31, 2006
- Messages
- 338
- Likes
- 138
- Location
- Montgomery, TX
- Website
- www.gulfcoastwoodturners.org
Ed - Ask Oneway. - John
My experience is if you can get it seated into your chuck it should work. Its not a precision tool, especially if the tab sits loose in the centerhole of your chuck but you can adjust that as needed.
I use it in Oneway chucks, but as long as the space at the center of the four jaws is wide enough to accommodate the tang when the jaws are about 1/8" from closed it will work fine.
- Joined
- Jul 18, 2018
- Messages
- 1,270
- Likes
- 2,666
- Location
- Baltimore, MD
- Website
- loujacobswoodturning.com
I use it on Nova chucks and it works for me.
Thanks for the replies. I'll give it a go.
I welded some (whatever thickness, can't remember) slats on the thin end of the mount side to fit into a Vicmarc chuck, works great for it now because I have a positive register on at least one side to center the spur into the chuck which enables a center for the point.