I’ve had a PM 2014 for about 5 years now. The tail stock has the round clamp plate on the bottom that takes a lot of force to keep the tail stock from moving in use. Saw the Oneway bowl steady hanging on the wall with the rectangular clamp plate. Ordered one from Highland Woodworking. They come threaded for a 1/2-13 bolt so luckily I have a set of 1/2” shank drills up to 1”. Centered it up in the drill press and drilled it out to 3/4”. Works great now. I don’t know if other Powermatic lathes use the round clamp plate but easy enough to change if they do. Those who might not be able to drill one out, can probably find a local shop for a few bucks. You just have to make sure you order the plate for the correct size between the rails.
-
November 2025 Turning Challenge: Wall Hanging! (click here for details) -
Sign up for the 2025 AAW Forum Holiday Swap by Monday, November 24th (click here for details) -
Congratulations to Konstantin Gusev for "The Nutcracker" being selected as Turning of the Week for November 17, 2025 (click here for details) -
Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.
PM 2014 tail stock clamp
- Thread starter Jim Holcombe
- Start date
- Joined
- Feb 6, 2010
- Messages
- 3,431
- Likes
- 2,505
- Location
- Brandon, MS
- Website
- threeringswoodshop.square.site
I think all PM lathes have the round plate at least my 3520B does. It does sometime need a small tap to stop the sliding but no real complaints about it. I just check it every now and then when turning.