Has anyone read, and know the location of, an article discussing headstock (or headstock lock clamp) casting failures on the Powermatic 3520A(?)?
Thanks!
Gil
Thanks!
Gil
-
July 2025 Turning Challenge: Turn a Multi-axis Weed Pot! (click here for details) -
Congratulations to Kent Reisdorph for "Sugarberry Bowl" being selected as Turning of the Week for July 14, 2025 (click here for details) -
Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.
PM 3520 Casting Cracks??
- Thread starter Gil Jones
- Start date
There was a thread on Wood Central. You might search there.
Papa Doc, thanks for the vector.
Is your's cracking?
Martin Braun said:
Seem to remember it was the locking plate rather than the main casting. Fix/revision was to go to a steel (rather than cast iron) plate.
m
john lucas
AAW Forum Expert
Your correct Mark, it was the cast iron locking plate below the headstock. That was taken care of a long time ago. That and the tool post locking levers were the first modifications I was aware of.
john lucas said:
CRS may be getting better. Must be the Summer Ale
Locking plate
I do not own a PM yet, just covering the bases. Thanks to y'all for the speedy info. Sounds like an old problem that has been modified.
I do not own a PM yet, just covering the bases. Thanks to y'all for the speedy info. Sounds like an old problem that has been modified.