My bandsaws blade is running near the edge of the Thrust bearing & I would like it perhaps in the middle. This is for the top and bottom. Is there a solution? See photo
-
November 2025 Turning Challenge: Wall Hanging! (click here for details) -
Congratulations to Craig Morton, People's Choice in the October 2025 Turning Challenge (click here for details) -
Congratulations to Andy Chen for "Mesquite Vase with Polymer Clay Millefiori" being selected as Turning of the Week for November 3, 2025 (click here for details) -
Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.
Powermatic 14” bandsaw
- Thread starter Marc Erthein
- Start date
I had to go look at mine. It is maybe 30 years old, has the cast iron body, and 3/4 hp motor. Mine runs sideways rather than the way yours does. The blade rides on the flat part of the bearing rather than on the round part. Not sure if that helps or not.
robo hippy
robo hippy