I have a few questions about bowl coring with my new powermatic 2014. It has a 1 HP 3 phase motor. It has a bed extension that will allow a 19 inch swing. I have recently purchased a Trent Bosch Hollowing Stabilizer. The TB system has both 3/4 bars and 1/2 inch bars and handles. It has a "gate" with 2 pins and 4 positions.
My questions are:
Has anyone else tried this?
Please let me know if you have or your thoughts on alternatives if this is not a good idea.
Thanks
Al in Texas
My questions are:
- Can this motor handle coring
- Would it be possible to use the McNaughton bars/cutters for coring with the TB Stabilizer? Can I swap out the bars I have with just the McNaughton bars?
Has anyone else tried this?
Please let me know if you have or your thoughts on alternatives if this is not a good idea.
Thanks
Al in Texas
Last edited: