Perhaps this is something super simple or common, because I can't find anything when searching for it. That's usually a good sign that I'm doing something terribly wrong.
Anyway, I have a Luguna 24/36 probably about 6 months old. When I pull the live center up to the drive center I find the live center is pointing at least 1/8th in below the drive center.
I'm not sure how to adjust this, or how long it's been going on. My lathe does tend to dance a jig every so often, but it is sitting on a new concrete slab that is pretty level.
Anyway, again, can someone advice me on how to adjust this alignment?
Thanks,
Raif
Anyway, I have a Luguna 24/36 probably about 6 months old. When I pull the live center up to the drive center I find the live center is pointing at least 1/8th in below the drive center.
I'm not sure how to adjust this, or how long it's been going on. My lathe does tend to dance a jig every so often, but it is sitting on a new concrete slab that is pretty level.
Anyway, again, can someone advice me on how to adjust this alignment?
Thanks,
Raif