I have the er32 robust collet and looking at the bottom of the collet there marked in 32nds
As to another turner has the same collets but his are marked 1/2 3/4
When I put my 1/2 bowl gouge in the 17/32 collet and slide it in to the notch on the gouge shaft it won’t tighten down enough to hold the gouge
Is it supposed to be a 1/2 inch collet or a 17/32 collet
As to another turner has the same collets but his are marked 1/2 3/4
When I put my 1/2 bowl gouge in the 17/32 collet and slide it in to the notch on the gouge shaft it won’t tighten down enough to hold the gouge
Is it supposed to be a 1/2 inch collet or a 17/32 collet