• The forum upgrades have been completed. These were moderate security fixes from our software vendor and it looks like everything is working well. If you see any problems please post in the Forum Technical Support forum or email us at forum_moderator (at) aawforum.org. Thank you
  • Congratulations to David Bartell, People's Choice in the March 2026 Turning Challenge (click here for details)
  • Congratulations to Chris Lawrence for "Dragon's Grip" being selected as Turning of the Week for March 30, 2026 (click here for details)
  • Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.

Savannah turning tool qualty

Gary Beasley

Gary Beasley

Joined
Sep 12, 2017
Messages
1,009
Likes
1,562
Location
Marietta, Georgia
image.jpeg image.jpeg I have a beef about a tool I bought a the wood show a few years back. Its a carbide tipped hook nosed hollowing tool with the Savannah brand on it. On the surface a nice looking tool with a 3/4 inch flat bar. A week ago I got it out to work on a greenwood red oak hollow form and the bar started to deform in a bad way, wasn't even putting a lot of torque on it. A closer look revealed the 3/4 inch bar was necked down to 1/4 inch at the handle and the shaft bent at that weakend point. Poor design or material or both.
 
Contact the seller. Not a good advertisement for their product. Thanks for the report.
 
Never heard of that brand and I bet that nobody in Savannah has either. :D

Stresses always concentrate at a discontinuity ... meaning a sharp corner. That sharp inside corner is an open invitation to problems ... small tang as John said and sharp corners. Look at a quality tool and you will see rounded inside corners where there is a possibility of bending stresses.
 
You must log in or register to reply here.
Back
Top