View attachment 77211
This one is the basic holder - just a round dowel in the post and a scrap of wood screws onto it, holes drilled through for mounting bolt (and you can see the bolt at the end where I made a threaded hole to hold the bolt when not in use)
View attachment 77212
LP1 mounted to the jig.
View attachment 77209
another view showing how it is bolted on (just a 1/4-20 bolt , lockwasher, and flatwashers for spacing, just snugged in finger tight)
View attachment 77213
and the resulting engraving (I just finished that today and went back out to the shop to get pictures, so I re-mounted it to give an idea..)
