Turning video recommendations

[Odie]

because there are a LOT of folks that truly believe that if they own lathe, and a sharpened tool that they should broadcast themselves.

This is true, Tim.

A lot of videos should never have been made public the first place. New turners have a hard time distinguishing between the good and bad.

There is a disconnect somewhere between freedom of expression, and information that truly helps in a way that propels the viewer to think and improve.

-----odie-----

 

[hockenbery]

I think this video is one that " may not be particularly un-safe for well experienced turners......"

The squirrel gets too many mini catches. I avoid Cutting toward the ways, cut toward the headstock for a catch free experience.

 

[Neil S]

Richard Raffan's books are classics and these two short videos give a nice introduction to his way of turning. I find the videos to be a joy to watch.

View: https://m.youtube.com/watch?v=TIvROyV2n6w

Richard has a whole series now up on YouTube.... some of the best from one of the best, IMO.

Most have been added since this thread was started...

https://www.youtube.com/channel/UC2tEGrCP1GiVwfaT4K9bcNw/videos