I have the 3/4 hp Delta VS 8" grinder like you get at Lowes.
Anyone using this with CBN wheels? I don't mind it taking a little time to get up to speed but I've read that it's not too hard to blow the internal fuse on them.
Lowest speed on it is about 2000rpm which should be just fine.
I'm assuming my best bet here will be the aluminum wheels from woodturnerswonders because they are lighter.
Anyone using this with CBN wheels? I don't mind it taking a little time to get up to speed but I've read that it's not too hard to blow the internal fuse on them.
Lowest speed on it is about 2000rpm which should be just fine.
I'm assuming my best bet here will be the aluminum wheels from woodturnerswonders because they are lighter.