I’ve been making small “bowls” from scraps using a glue block to maximise the depth I can make. Hot melt glue is easy to use and holds small pieces well enough. However parting off is a bit of an issue. I’ve used 1/16 parting tool- gets coated with glue: Japanese saw- needed the blade heating up on the stove wrapped in kitchen paper! I can part off at the base of the bowl but it rather defeats the objective of maximising depth. Or part the glue block off leaving a disc the store be removed with a knife. None are wholly satisfactory Suggestions welcome! Does alcohol dissolve the glue (though I’m not wasting the gin!)